12
132.9 cm
68.9 cm
2.5 cm
2.5 cm
To ensure sufficient clearance for water lines and airflow,
allow minimum clearances of at least 2.5 cm at the sides
and 10 cm behind the unit. Be sure to allow for wall,
door, or floor moldings that may increase the required
clearances.
75.6 cm
128.3 cm
50.8 cm additional
needed for service
Unpacking and removing
shipping material
1
•
After removing the carton and shipping material,
lift the washer off the foam base. Make sure the
plastic tub support comes off with the base and
is not stuck to the bottom of the washer.
Plastic Tub
Support
Carton Base
•
If you must lay the washer down to remove the
base packaging materials, always protect the
side of the washer and lay it carefully on its side.
DO NOT lay the washer on its front or back.
2
•
Save the foam block for future use. If the washer
must be moved in the future, the foam block
will help prevent damage to the washer during
transportation.
NOTE
•
To prevent damage, do not remove the foam block
until the washer is at the final location.
3
Turn the top cover about 180 degrees. Cover the
upper hole with the top cover and install 4 short
screws (included in packing box) to fix it in place.
MFL69482502_EN.indd 12
16. 4. 5. 오전 9:16
