8. Accessories
15
THERMA V
Split Type
DHW Tank Integrated Unit
̰
Accessory Part List
8.1.2 Installation Guide
1.
ྡ
Connect CN_OUT with Outdoor Unit by the cable(provided).
2.
ྞ
,
ྟ
Connect RS-485 BUS_A(+) and BUS_(B)(-) with other network products.
(ex. Central Controller, I-Gateway.....)
3.
ྠ
Select DIP Switch Configuration.
4. Connect CN_PWR with Outdoor PCB Power connector.
5. After Power is ON, check the Communication LED
ྙ
• LED2G(Yellow), LED3G(Orange)
– Normal : LED blinks continuously
– Error : Check the DIP Switch setting & wiring connections0
6.
ྚ
Check RS-485 Communication Status LED:
– Normal : LED blinks when PI485 receives data from central controller.
– Error : Check the wiring connections.
7. Finally if all of the above steps are OK, then tie the cables by tie wraps & clamp
CAUTION
• Install the modbus converter after checking the hole for screw.
8.1.3 DIP Switch Configuration
CAUTION
•
Switch No.1 and 2 sould be ON, and all others should be OFF.
• The wrong setting of DIP switches could cause malfunctioning.
Switch setting must be done carefully.
• Push the Reset button after changing the DIP switch.
PP485B00K
BRACKET (1EA)
Multi-V
Multi-V
Multi
WIRE ASSY 1(1EA)
SCREW (4EA)
WIRE ASSY 2(1EA)
WIRE ASSY 3(1EA)
ON
1
2
3
4
5
6
7
8
Others :
Tie Wrap (3 EA) - Cable Tie
Clamp (1 EA)
X Y Z [ \ ] ^ _
vu
Summary of Contents for 5BPU0-02C
