LG-Ericsson GDC-400H, User Manual

Page: 50 / 64

GDC-400H Wireless Handset
User Guide
37
6.3.2 Subscription to LWS-BS
In order to obtain services from a LWS-BS, the handset must establish a subscription with the LWS-BS.
When subscribing to the LWS-BS you will need the RFPI, which may be available from your System
Administrator. Also, before starting the subscription process make sure you are in range of the LWS-BS.
To subscribe to LWS-BS, from the GDC-400H:
1. Verify that Press the Menu ( ) button to display the menu.
2. From the menu use the Navigation ( ) button to highlight Phone Register
3. Press the OK ( ) left soft button to display the Phone Register menu.
4. Select “LWS Subscription” using the up and down arrows of the Navigation ( ) button and
press the OK ( ) button.
5. The GDC-400H searches for the system and displays “Searching..1”. When a system is found, its
RFPI, is displayed (verify with your System Administrator, or the Attendant).
6. Press the OK ( ) button to subscribe to the system (RFPI shown). Press No ( ) button to
continue searching.
7. Press the OK ( ) button; confirmation tone will be heard is received at the GDC-400H and LWS-
BS LCD will display “Subscription Done”.
8. Press the End ( ) button.
If the subscription fails, repeat above Steps 3 - 6 from the Attendant Station, and Steps 1 - 7 from the GDC-
400H.
 Note
According to the system or radio channel environment, the system or the wireless terminal periodically may
not recognize that the system has the subscribed wireless terminal or the wireless terminal is subscribed to
the system. Once a user has performed the subscription procedure, try to make a call first. Then, if a user
can’t make a call, try to subscribe the wireless terminal again after verifying the terminal is unsubscribed
(described in the following chapter). It is recommended all other DECT systems be disabled while
performing the Subscription procedure.
6.3.3 Selecting a DECT Zone
While the handset may subscribe to four zones simultaneously, the handset can only be active in one. You
may select the active Base station to control the zone in use. If not already registered to the base, you can
subscribe for services from the zone.
To change the active zone:
1. From the User Menu, select the Phone Register menu.
2. Select Base Choice from the Phone register menu.
3. Use the up down arrows on the Navigation ( ) button to select a Base (1 ~ 4) or Best Choice.
4. Press the OK ( ) left soft button. This handset searches for the selected zone and displays
“Searching x”; when located, the idle mode display is shown and services are available.
5. Once the base is found, it is an active base.
6.3.4 Modify PIN
The Handset PIN (Authorization code) can be changed (default=0000).
To change the H/S PIN:
1. From the User Menu, select the Phone Register menu.