LG-Ericsson GDC-400H, User Manual

Page: 26 / 64

GDC-400H Wireless Handset
User Guide
13
2.8 Registering the GDC-400H to a LWS-BS (LG-Nortel Wireless
SOHO-Base Station)
Prior to accepting a connection with a GDC-400H, a registration to services must be entered into your LWS
system. This is accomplished in a two step process: the LWS-BS enables registration of a phone to the
system, then the GDC-400H subscribes to the LWS-BS for services.
2.8.1 Enabling Registration
To enable a registration, from the LWS-BS;
1. Press [Menu] button.
2. Press [Digit 1] (CONFIGURATION submenu), or
Select [1. CONFIGURATION] using Navigation up/down key and [OK] Button.
3. Press [Digit 4] (STATION REGISTRATION submenu), or
Select [1. STATION REGISTRATION] using Navigation up/down key and [OK] Button.
4. Press [Digit 1] (REGISTER STATION submenu), or
Select [1. REGISTER STATION] using Navigation up/down key and [OK] Button.
5. Select the phone type using Navigation left/right key (GDC-4XX).
6. Press Navigation
[OK] button or [OK] soft key.
7. When the registration is completed below message is shown on LWS-BS LCD.
STATION: 10X
SUBSCRIBED: SUCCESS
 Note:
Don’t press Monitor or Speaker button at the LWS-BS until the GDC-400H completes the registration
and registration confirmation tone is heard.
2.8.2 Registering to the LWS-BS
When registering to LWS-BS you will need the system’s unique Radio Frequency Personal Identification
(RFPI). Also, before starting the registration process make sure you are close to an active LWS-BS.
To register to the system, from the GDC-400H:
1. Press the Menu ( ) button to display the menu.
2. From the menu use the Navigation ( ) button to highlight Phone Register.
3. Press the OK ( ) button; this displays the Phone Register menu.
4. Select “LWS Subscription” using the up and down arrows of the Navigation ( ) button and press
the OK ( ) button.
5. The GDC-400H searches for the LWS-BS, displaying and “Searching..1”. When a LWS-BS is found,
its RFPI, is displayed. The RFPI of your LWS-BS is available from your System Administrator, or
perhaps the attendant.
6. Press OK ( ) button while highlighting the RFPI to continue the registration to the system, or
Press No ( ) button to continue the search.
7. Press OK ( ) button; on successful registration, a confirmation tone is received at the GDC-400H
and the LWS-BS.
8. If the registration fails, repeat procedure from Step 1 to 6 at the LWS-BS and Step 1 to 7 from the
GDC-400H (refer to Note).