LG-Ericsson GDC-400H, User Manual

Page: 49 / 64

GDC-400H Wireless Handset
User Guide
36
6.3 Phone Register
To register a new wireless terminal to your base or to register a wireless terminal again after base reset
(refer to the Section Base Reset).
1. Press the Menu ( ) button to display the User menu.
2. From the User Menu use the Navigation ( ) button to highlight Phone Register
3. Press the OK ( ) left soft button. This displays the Phone Register menu.
 LWS Subscription
 Subscription
 Base Choice
 Modify PIN
 Base ID
 Reset
4. From the Phone Register menu select “Subscription” using the up and down arrows of the Navigation
( ) button and press the OK ( ) button.
 Note
From the Phone Register menu select “ LWS Subscription” using the up and down arrows of the
Navigation ( ) button and press the OK ( ) button to register your wireless terminal to
LWS-BS (LG-Nortel Wireless SOHO-Base Station)
5. Select an available BASE station number and press OK ( ) button. The GDC-400H searches for
the system, displaying and “Searching..x”. When a system is found, the corresponding Radio Fixed
Part Identification (RFPI) is displayed (verify the RFPI with the System Administrator or Attendant).
6.3.1 Subscription
In order to obtain services from a base station or zone, the handset must establish a subscription with the
zone. The handset may subscribe to four (4) base stations or zones simultaneously. When subscribing to
the system you will need the RFPI and Authorization code, which may be available from your System
Administrator. Also, before starting the subscription process make sure you are in range of the desired zone
and the Received Signal Strength Indicator (RSSI) indicator is steady, showing at least 2 bars.
To subscribe to a system, from the GDC-400H:
1. Verify that Press the Menu ( ) button to display the menu.
2. From the menu use the Navigation ( ) button to highlight Phone Register
3. Press the OK ( ) left soft button to display the Phone Register menu.
4. Select “Subscription” using the up and down arrows of the Navigation ( ) button and press the
OK ( ) button.
5. Select an available BASE number (up to 4) and press the OK ( ) button; the GDC-400H
searches for the system and displays “Searching..x”. When a system is found, its RFPI, is displayed
(verify with your System Administrator, or the Attendant).
6. Press the OK ( ) button to subscribe to the system (RFPI shown). Press No ( ) button to
continue searching.
7. Enter the Authorization code (available from the System Administrator, as needed).
8. Press the OK ( ) button; confirmation tone will be heard is received at the GDC-400H and the
Attendant’s LCD will display “Subscription Done”.
9. Press the End ( ) button.
If the subscription fails, repeat above Steps 3 - 6 from the Attendant Station, and Steps 1 - 8 from the GDC-
400H.