Lexmark Optra N 4040, Reference Handbook

Page: 67 / 259

3-4
Laser Printer Reference Handbook
4033
• Models 20X and 30X:
The following LED sequence occurs during a normal reset. A
successful reset results in the Power and Status LEDs on and the
Test and Data LEDs off.
If an error is detected the LEDs will hang in their current state. Reset
again and replace the adapter if the error recurs.
Symptoms after Reset
The Status LED blinks to indicate an error was detected after a
successful Reset. The Test and Data LEDs indicate what type of error
was detected.
Note: If you are updating the flash code, the Status, Test, and Data
LEDs will all blink. This does not indicate an error.
Status Test Data
off off off
on on on
off on on
off on off
off off on
off off off
on off off
Model 0XX
Symptom Action
Status LED on The adapter is functioning correctly. “Wrap
Test for Adapter Ports” on page 3-5.
Status LED blinking There is a problem with the adapter or the
LAN. “LAN Connection Check” on page 3-6.
Status LED off Replace the operator panel board. If the
problem recurs, replace the adapter.
Models 2XX, 3XX
Status Test Data Error Action
blink off off software Contact next level of support.
blink off on network Refer to Printer and LAN
Checks.