Lexmark Optra N 4040, Reference Handbook

Page: 152 / 259

4040
6-25
4040
Wrap Tests
The Wrap Tests check the circuits used to communicate with the host
computer.
To run the Wrap Test:
1. Turn the printer off.
2. Disconnect the interface cable.
3. Install the wrap plug in one of the interface cable connectors.
4. Install the parallel wrap plug part no. 1319128 for the parallel test
or install the 25- pin serial wrap plug part no. 1329048 for the
serial test.
5. Enter Diagnostics mode.
6. Select [HARDWARE TESTS].
7. Select [Wrap Test].
8. Select [Parallel] for the parallel port or [Serial] for the 25- pin
serial port.
9. Select [Single] or [Continuous].
10. Select [CANCEL] to stop continuous.
A [Passed] message indicates the printer connection to the
printer cable connector is good.
A [Failed] message indicates a defective RIP board.
Note: Ignore the number displayed after a failure is displayed.
11. Press Return to return to the Diagnostics mode main menu.
12. Turn the printer off, then remove the wrap plug from the interface
connector.