Lexmark Optra N 4040, Reference Handbook

Page: 147 / 259

6-20
Laser Printer Reference Handbook
4040
Diagnostics Mode Tests
Button Test
To test the operator panel buttons:
1. Enter Diagnostics mode.
2. Select [HARDWARE TESTS].
3. Select [Button Test].
4. Press each button. [Closed] is displayed until the button is
released. Then [Open] is displayed.
5. Press Return to return to the Diagnostics mode main menu.
Defaults
Allows setting the following defaults to U.S. or Non U.S. values.
1. Enter Diagnostics mode.
2. Select [PRINTER SETUP].
3. Select [Defaults].
4. Select [U.S.] or [NON U.S.].
5. Press Return to return to the Diagnostics mode main menu.
Disk Test/Clean
This is a 90 minute test that should be performed only on a disk that
contains bad data and is therefore unusable.
This test destroys all data on the disk by doing a multi-pass read/write
on every block of the disk. Bad blocks are flagged and removed from
use. If over 2,000 bad blocks are found, the test stops and the display
indicates the disk must be replaced.
A message describing test progress is displayed during the test.
1. Enter Diagnostics mode.
2. Select [DEVICE TESTS].
3. Select [Disk Test/Clean].
4. Select [CONTINUE] to start the test, or [CANCEL] to return to
Diagnostics mode main menu.
5. Select [CANCEL] to interrupt the test.
6. Press Return to return to the Diagnostics mode main menu.
U.S. NON U.S.
Letter size paper A4 paper
Symbol Set Roman-8 Symbol Set PC-850