Lenovo ThinkServer RD210, Hardware Maintenance Manual

Page: 132 / 182

1. Read the safety information in Chapter 2 “Safety information” on page 3 and “Installation guidelines”
on page 67.
2. Turn off the server and peripheral devices and disconnect all power cords.
3. Remove the cover (see “Removing and replacing the cover” on page 72).
4. Align the holes on the PCI riser card and the PCI bracket and install the screw that attaches the PCI
riser-card to the PCI bracket.
1
PCI riser-card bracket
2
Screw
3
PCI riser-card
5. If you need to install an adapter, see “Removing and installing an adapter” on page 82.
6. Install the PCI riser card assembly (see “Removing and installing a PCI riser-card assembly” on page 81).
7. Reconnect the cables for the adapter.
8. Install the cover (see “Removing and replacing the cover” on page 72).
9. Slide the server into the rack.
10. Reconnect the power cords and any cables that you removed.
11. Turn on the peripheral devices and the server.
Removing and installing a remotely installed RAID adapter battery
To remove and install a remotely installed RAID adapter battery, complete the steps in this section.
Removing a remotely installed RAID adapter battery
If a RAID adapter battery is installed remotely on the microprocessor 2 air baffle and you need to replace it,
complete the following steps:
1. Read the safety information in Chapter 2 “Safety information” on page 3 and “Installation guidelines”
on page 67.
2. Turn off the server and peripheral devices and disconnect all power cords.
3. Remove the cover (see “Removing and replacing the cover” on page 72).
4. From the top of the microprocessor 2 air baffle, remove the battery retention clip that holds the battery in
place. Press the release tab toward the front of the server and remove the battery retention clip.
124
ThinkServer RD210 Hardware Maintenance Manual