Leica VT1200, Instructions For Use Manual

Page: 43 / 64

43
Leica VT1200 / Leica VT1200 S
Operating the VibroCheck
6
6.2 Using the VibroCheck with the Leica VT1200 S
Warning
The following instructions must be adhered to exactly. Noncompliance can cause serious damage to
the instrument.
We recommend using the VibroCheck after each blade change for checking the optimum position of the
blade and important sectioning parameters.
Fig. 24
1
2
3
1 Foot switch for VT
2 VibroCheck
3 Control panel for VT
Fig. 25
4
5
Prior to assembly, the dovetail guide (
→
Fig. 25- 4 ) is brought down to the lowest position using the
DOWN key!
1. The user installs the VibroCheck: Push the VC along the dovetail guide (
→
Fig. 25- 4 ) to behind
the mark on the baseplate of the instrument (rear stop) and clamp it down using the lever
(
→
Fig. 25- 5 ) . Insert the blade and clamp tightly. Return the blade to the cutting position (see
(
→
Fig. 17) ).
2. Plug the connecting plug of the VibroCheck (VC) into the corresponding socket ( → Fig. 24- 2 ) on
the left side panel. Short red flash of LED on VC --> it then remains red. Control panel detects VC
see (
→
Fig. 26) . The LED in the DOWN key flashes green.