48
Instruction Manual V1.1 01/2001
15. Accessories
4
5
1
Fig. 48.1
3
2
15.5.3 Knife holder E
The knife holder E is designed for conventional dispos-
able blades from different manufacturers.
It is available in two versions:
With pressure plate for low profile blades and with
pressure plate for high profile blades.
Both pressure plates also are available as accesso-
ries. If you would like to change from one blade type to
another, just order the required type of pressure plate.
The pressure plate can be exchanged easily.
Inserting the blade
Push the knife guard
(1)
to the middle.
To insert the blade, relocate the clamping lever
(2)
down.
Carefully insert the blade
(3)
from the side.
To clamp the blade, relocate the clamping lever
(2)
up.
Changing the pressure plate
Loosen the 4 screws
(4)
on the back of the knife
holder by using an Allen key size 4.
Remove the pressure plate
(5)
.
Attach the new pressure plate by tighten the 4
screws
(4)
.
Cleaning
The clamping plate
(7)
can be removed for cleaning.
To remove the blade, relocate the clamping lever
(2)
down.
Carefully remove the blade.
Pull out the clamping lever
(2)
.
Remove the clamping plate
(7)
.
Only use mild commercial detergents or soap
solution for cleaning!
Do not use solvents that contain acetone and
xylene!
Clean the knife holder with a damp not a wet cloth.
Place the clamping plate
(7)
on the holder ensuring
that the upper edge of the clamping plate and of
the pressure plate
(5)
are parallel and at the same
height.
Insert the clamping lever
(2)
in the hole and relo-
cate it up.
7
Fig. 48.2
2
5
Convenient for left-handers:
The clamping lever (2) can also be inserted in
the hole on the left side of the knife holder.
This will however change the locking posi-
tion of the lever!
To unlock, relocate the lever upward; to
clamp, relocate the lever downwards.
Summary of Contents for RM2155
Page 2: ......
