12
2014+ XL Raider
1.
See Fig. 1
. Install adjuster bolts and jam nuts to
each side of swingarm as shown. Bolt head
will face front of bike. Thread bolt into swin-
garm just enough to thread nut on backside.
•
(2) Adjuster Bolt M10 X 100 (CB1608)
•
(2) Jam Nut M10 (CN1912)
2. Support swingarm with jack stands.
3.
See Fig. 2
. Attach differential assembly to
swingarm as shown.
•
(4) Bolt M12 X 30 (CB1987)
•
(4) Nut M12 (CN1917)
NOTE: Swingarm plates will sit above differen-
tial plates Slide differential as far forward as
possible. Set jack stands under axle tubes.
4. Tighten pinch block hardware just enough to
allow differential to slide on swingarm plates.
5.
See Fig. 3
. Remove upper, lower and rear
housing plates.
6.
See Fig. 3
. Carefully slide belt over front and
rear pulleys.
7. Reinstall housing plates with original hardware
using Loctite 242. Install all hardware before
tightening. Torque hardware to
17 ft. lbs.
DIFFERENTIAL INSTALLATION
Fig. 2
Fig. 1
Fig. 3
Jam nut
Adjuster
Swingarm plate
on top
Differential
plate
Remove
plates
Install belt
