27
2014+ XL Raider
1. Lay down top body support so that it is level with
frame.
2.
See Fig. 1
. Slide body around RH bracket and up
over HD frame. Install seat center post with sup-
plied 5/16” fender washer on bolt head.
Leave
this bolt loose.
Body will sit under mounting tab.
•
(1) 5/16” Fender Washer– CW2109
3. Raise top support back up and let body rest on it.
4. Attach body to front mounts using the following
hardware. Leave hardware loose.
•
(2) 1/4” x 1-1/2” Button Head- CS4031
•
(4) 1/4” Flat Washers– CW2005
•
(2) 1/4” Lock Nut– CN3040
5. Install
shocks.
Torque LH shock bolts to 45 ft.
lbs
.
Torque RH upper shock bolt to 45 ft. lbs
.
Torque lower RH shock bolt to 23 ft. lbs.
NOTE: Adjust shocks to middle setting
6. Set bike on jack stands to achieve proper ride
height.
7. Measure body from side to side and front to back.
Top body support may be adjusted to move body
up or down. Be sure to leave enough clearance for
mufflers on back of body. Exhaust will still be loose
and need to be held in place to check clearance.
8.
See Fig. 2
. Verify there is at least a 1/4” gap be-
tween the body and chrome belt cover on RH side.
9.
See Fig. 3
. Once body is in place, push LH
bracket flush against body and tighten bracket to
frame. Using bracket as a guide drill two 1/4” holes
through trunk wall. Attach using the following hard-
ware. Bolt head, fender washer and rubber washer
will go inside trunk.
•
(2) 1/4” x 1” Button Head- CB1086
•
(4) 1/4” Fender Washers– CW2108
•
(2) 1/4” Rubber Washers– FG1002
•
(2) 1/4” Flat Washers– CW2005
•
(2) 1/4” Lock Nut– CN3040
BODY INSTALLTION
Fig. 2
Fig. 1
Fig. 3
LH body bracket
hardware inside
trunk
Minimum 1/4’
gap between
body and cover
