28
2014+ XL Raider
10.
See Fig. 4
.
Before drilling RH bracket holes,
push exhaust away from differential hous-
ing
. Exhaust pipes should be at least 1” away
from housing (
verify pipes are straight
). A
wedge can be used to hold pipes in place while
you tighten bracket to frame and drill two 1/4”
holes. Attach to body using the following hard-
ware.
•
(2) 1/4” x 1” Button Head- CB1086
•
(4) 1/4” Fender Washers– CW2108
•
(2) 1/4” Rubber Washers– FG1002
•
(2) 1/4” Flat Washers– CW2005
•
(2) 1/4” Lock Nut– CN3040
11. Before tightening rest of exhaust, make sure
that there is proper clearance along both pipes.
Rear head pipe may need to be pulled away
from park brake bracket.
12. Tighten all exhaust clamps and nuts.
13. Reinstall all HD heat shields along with Leh-
man heat shield to lower (front header) pipe.
•
(1) Heat Shield– GS914
11. Tighten seat center post, front bracket bolts,
and top body support jam nut.
12. Install passenger footpads using the following
hardware.
•
(6) 1/4” Flat Washers– CW2005
•
(6) 1/4” Lock Nuts– CN3040
16.
See Fig. 5
. Set seat in place and center it on
trike. Mark rear hole and drill using a 31/64” bit.
Install 1/4” well nut into body. Install seat using
the following hardware.
•
(1) 1/4” Well Nut– CN3400
•
(1) 1/4” x 1” Phillips Screw– CS4080
•
(1) 1/4” SS Washer– CW2006
BODY INSTALLTION
Center seat on
body and drill hole
Fig. 4
Fig. 5
