5
2014+ XL Raider
NOTE
:
Refer to H-D service manual for detailed
instructions on the proper removal of OEM parts.
1. Place motorcycle on motorcycle lift. Make sure
bike is standing straight up and handlebars are
centered.
2. Raise motorcycle and properly support frame with
center stand. Verify frame is level.
3. Remove seat.
4. Remove side covers and disconnect battery.
NOTE: Always disconnect the negative battery ca-
ble first.
5. Remove
side
stand.
6. Remove LH passenger foot peg.
7. Disconnect rear wiring harness.
8. Remove and save rear turn signals from fender.
9. Remove rear fender assembly from motorcycle.
NOTE: Unplug oxygen sensors before removing
head pipes.
10. Remove mufflers, heat shields and head pipes
from motorcycle. Save exhaust hardware.
11. Remove chrome belt cover. Save cover and hard-
ware for reinstallation. Remove belt from motorcy-
cle. Mark belt orientation for reinstallation.
12. Remove rear brake line and remove caliper.
13. Remove shocks. Save LH mounting bolts.
14.
See Fig. 1
. Remove rear master cylinder and RH
passenger foot peg assembly .
15. Remove rear wheel assembly.
NOTE: OEM swingarm pins will not be reused on
2014+ models.
17. Remove swingarm from H-D frame. Bearings
should be pressed out and reinstalled in trike swin-
garm, Replace bearings if they show signs of wear
or damage.
18.
See Fig. 2
. Remove rear brake line clamp and
plugs from rear frame.
PREPARING THE MOTORCYCLE
Master cylinder
Remove clamp
Fig. 1
Fig. 2
Remove plugs
RH foot peg
