User Manual for ELD5 Servo
(V1.00)
www.leadshine.com
65
7.1.2 Timing chart on power-up
r,t control power
inner control power
R,S,T main power
BUS voltage
Servo ready
Servo on input
Dynamic brake
Motor power on
BRK-OFF
Position/velocity/torque command
off
on
on
on
on
on
on
on
on
on
have
off
off
off
off
off
off
off
off
no
<0.5 second
>0 millisecond
<0.8 second
<1.5 second
>0 millisecond
<10 millisecond
<0.15 second
<10 millisecond
>0.1 second
7.1.3 Timing chart on fault
No fault
Have fault
alarm
No alarm
<150ms
7.1.4 holding brake
In applications where the motor drives the vertical axis, this brake would be used to hold and prevent the work
(moving load) from falling gravity while the power to the servo is shut off .
Never use this for “Brake” purpose to stop the load in motion.
Use this built-in brake for “holding” purpose only. That is to hold the stalling status.
For the brake release timing at power-on ,or braking timing at servo-off/servo-alarm while the motor is in
motion ,refer to chapter 7.1.2 timing chart on power-up.
You can follow the diagram about the wiring below :
