User Manual of EL6-CAN AC Servo
www.leadshine.com
11
Chapter 2 Installation
2.1 Storage and Installation Circumstance
Table 2.1 Servo Drive, Servo Motor Storage Circumstance Requirement
Item
EL6 series drive
Servo motor
Temperature
-20-80
℃
-25-70
℃
Humility
Under 90%RH (free from condensation)
Under 80%RH(free from condensation)
Atmospheric
environment
Indoor(no exposure)no corrosive gas or
flammable gas, no oil or dust
Indoor(no exposure)no corrosive gas or
flammable gas, no oil or dust
Altitude
Lower than 1000m
Lower than 2500m
Vibration
Less than 0.5G (4.9m/s
2
) 10-60Hz (non-continuous working)
Protection
level
IP20(no protection)
IP54 or IP65
Table 2.2 Servo Drive, Servo Motor Installation Circumstance Requirement
Item
EL6 series drive
Servo motor
Temperature
0-55
℃
-25-40
℃
Humility
Under 90%RH
(free from condensation)
Under 90%RH
(free from condensation)
Atmospheric
environment
Indoor(no exposure)no corrosive gas or
flammable gas, no oil or dust
Indoor(no exposure)no corrosive gas or
flammable gas, no oil or dust
Altitude
Lower than 1000m
Lower than 2500m
Vibration
Less than 0.5G (4.9m/s
2
) 10-60Hz (non-continuous working)
Protection
level
IP20(no protection)
IP54 or IP65
2.2 Servo Drive Installation
Notice
Must install in control cabinet with sufficient safeguarding grade.
Must install with specified direction and intervals, and ensure good cooling condition.
Don’t install them on inflammable substance or near it to prevent fire hazard.
Install in vertical position ,and reserve enough space around the servo drive for ventilation.
The user may install the product in the mode of bottom plate installation or panel installation, and the
installation direction is perpendicular to the installation face. In order to ensure good heat dissipation
conditions, at least 10MM of installation space should be set aside in the actual installation.
When mounting drives compactly, consider installation tolerances and leave at least 1MM between each
two drives. Use it below 75% of the actual load rate.
Installation diagram as follow: