8. CONFIGURATION
70
8.7.2
Power-on Panel Settings
You can save the power-on panel settings in the START UP MEMORY configuration screen.
For a list of the items that can be saved, see “Startup” in Table 12-4, “List of settings.”
The LT 450 does not store the panel settings when you turn off the power. When you turn the
LT 450 on, the panel settings that have been stored using the START UP MEMORY menu
screen are recalled.
The panel settings you make here are not stored to preset memories. They are also not
reset if you initialize the settings.
●
Settings
STORE TO LT450
Store the current panel settings to the LT 450 memory. The next
time the LT 450 is turned on, these settings will be loaded. If
startup memory is already stored in the LT 450 memory, it will be
overwritten.
COPY INT
→
USB
Save the startup memory that is stored in the LT 450 memory to
USB memory. If startup memory is already saved on the USB
memory device, it will be overwritten.*
1
COPY USB
→
INT
Load the startup memory that is saved on USB memory to the LT
450 memory. If startup memory is already stored in the LT 450
memory, it will be overwritten.*
1
*1 Do not remove the USB memory or turn the LT 450 off while startup memory is being copied.
You cannot load presets that are saved on USB memory to the LT 450 memory if the presets were
saved on an LT 450 whose firmware was 3.9 or earlier.
●
Procedure
MENU
→
PRESET SETTING
→
START UP MEMORY
Figure 8-25 Power-on panel settings
*
The figure above shows an example of the screens that appear when you select STORE TO
LT450.
Similar screens appear when you select COPY INT
→
USB or COPY USB
→
INT.