8. CONFIGURATION
53
If you set ID MODE to HDMI_INFO, the LT 450 displays HDCP and CEC information for
HDMI and DVI-I (including those on options) in four lines as shown below. The following
figure shows an example when an LT 45SER01 (DVI-I unit) is installed in slot 1, an LT
45SER02 (HDMI unit) is installed in slot 2, and an LT 45SER03 (SCART unit) is installed in
slot 3.
Figure 8-8 HDCP and CEC information
Each item is explained below.
Line 1
Contains the title.
Line 2
Indicates columns for the LT 450 HDMI, the LT 450 DVI-I, slot 1, slot 2, and slot 3. Slots 1 to
3 appear even if there is no option installed. The letters A and B are for the two connectors
on the LT 45SER02 (HDMI unit) when it is installed.
Lines 3 and 4
Indicate whether the device connected to the LT 450 supports HDCP or CEC. The five
available indications are PASS, FAIL, ----, OFF, and blank. FAIL appears in line 4, and all
other indications appear in line 3. The following table describes each indication.
Set HOT PLUG, HDCP, and CEC according to the procedures given in section 8.8.2,
“Configuring the HDMI Output,” section 8.9.2, “Configuring the DVI-I Output,” section 8.10.2,
“Configuring the DVI-I Output on an Option,” and section 8.11.2, “Configuring the HDMI
Output on an Option.”
Table 8-2 HDCP and CEC information
HOT PLUG
HDCP, CEC
Display Conditions
PASS
ON
At least one is ON
When the connected device supports all items that
are set to ON.
FAIL
ON
At least one is ON
When the connected device does not support any of
the items that are set to ON.
---- ON
-
When a device is not connected.
When HDMI OUTPUT or DVI OUTPUT is set to DIS.
OFF
OFF
Both are OFF
When HOT PLUG is OFF or when both HDCP and
CEC are OFF.
Blank
When an option is not installed in the slot.
When an option that does not support HDCP or CEC is installed.
Under the “B” column when an LT 45SER01 (DVI-I unit) is installed in the slot.
*
DVI-I does not have CEC.