Leader Electronics Corp. LT 443D, Instruction Manual, Page: 22 / 239

3-2
u
MEMORY CARD slot
To insert memory card to store the optional NATURAL PICTURE pattern.
Procure a compact flash memory card recommended by Leader Electronics Corp. Refer to
Section 2.3.4, “Memory Card Slot” for detail.
＊
Note: When formatting a CF card, use the FAT system; the LT 443D cannot recognize the
CF card formatted in FAT32 system.
To format the CF card of 32 MB or larger capacity on Windows XP, select FAT from
the default (FAT32 file system selected) for formatting.
Notes on using CF memory card:
• A “Vcc = 5 V” type memory card cannot be used.
• Insert the memory card until it in place. If the card cannot be inserted properly, check the
card for up side down. Do not insert the card forcibly. It may cause trouble.
• Do not remove the card while writing or recalling data.
• Do not turn power off while writing or recalling data.
i
USB connector
Used for maintenance in the factory. This connector will be installed.
o
KEY LOCK switch
Turns on and off the key lock mode.
!0
Ventilation hole
To prevent instrument damage due to overheating, do not block airflow through the ventilation
vents (i.e., air-intake vents on the rear panel and exhaust holes on the front panel).
3.2 Rear Panel
Figure 3-2 shows the LT 443D rear panel.
!1
UNIT 1 compartment
!2
UNIT 2 compartment
!3
UNIT 3 compartment
!4
UNIT 4 compartment
Figure 3-2
!1 !2 !3 !4 !5 !6 !7 !8
UNIT1 UNIT2 UNIT3 UNIT4