Leader Electronics Corp. LT 443D, Instruction Manual, Page: 140 / 239

SD/SDB-14
4.6.2 ID POSITION
This mode is used to position the ID characters.
(1) Select [ID POSITION] by pressing the Up or Down key, then press the [ENTER] key.
3. ID POSITION
■
H: 0 DOT
□
V: 0 DOT
Hierarchy level 3
(2) Position the [
■
] to [H] or [V] by pressing the Left or Right key, then set the number of
dots by pressing the Up or Down key. The upper-left corner of the monitor screen is the
reference (0, 0) when setting the parameters in dots.
(3) Pressing the [ENTER] key enters data. The menu returns to hierarchy level 2 [2. ID
CHARACTER].
4.6.3 ID SIZE
This mode is used to set the character size.
(1) Select [ID SIZE] by pressing the Up or Down key, then press the [ENTER] key.
3. ID SIZE
■ x1 □ x2
Hierarchy level 3
(2) Position the [
■
] to [x1] or [x2] by pressing the Left or Right key, then press the [ENTER]
key. The menu returns to hierarchy level 2 [2. ID CHARACTER].
4.6.4 ID LEVEL (Setting Character Brightness)
This mode is used to set the ID character brightness.
(1) Select [ID LEVEL] by pressing the Up or Down key, then press the [ENTER] key.
3. ID LEVEL
■ 100 % □ 75 %
Hierarchy level 3
(2) Position the [ ■ ] to [100 %] or [75 %] by pressing the Left or Right key to select the
brightness for easy reading: 100 % for white, 75 % for light gray.
Press the [ENTER] key. The menu returns to hierarchy level 2 [2. ID CHARACTER].
4.6.5 ID BLINK (Setting Blinking Time)
This mode is used to set the ID character blinking time and turn on or off. This mode can
also be used for checking the system operation status when the stationary pattern is
displayed.