Laundrylux CROSSOVER 2.0 Series, Training Manual

Page: 56 / 74

Figure 4: Seal Orientation
Step #2: Pulley Wheel-side seal (smallest)
Apply a thin film of Amblygon grease to the outside wall of the smallest seal. Seat the seal in the bearing
housing noting the orientation (Figure 4). Using the same tool set up as Step #1, “GENTLY” tap the seal
into place.
Step #3: Middle seal
Apply a thin film of Amblygon grease to the outer wall of the seal noting the orientation is opposite of the
two other seals (Figure 4). With the seal edge facing the water side of the machine place a dab of RTV
adhesive on the seal's tab-key and carefully feed the seal's tab into the mating slot in the bearing housing.
The seal will be slightly askew, but the tab will not be deformed when the whole seal is seated in place.
Then using Washer (Item# 3) centered on the seal, tap the seal gently into place starting on the opposite
side of the seal tab and then drive the seal gently and evenly until it is seated. (Figure 5). The washer
should overlap the seal wall when seating to prevent deformation of the seal.