Laundrylux CROSSOVER 2.0 Series, Training Manual

Page: 58 / 74

Flip the rear outer drum over (pulley side up). Apply a thin film of Amblygon grease on the outer and inner
walls of the smaller bearing and center on the bearing housing. Cover bearing with one of the two 2.75"
dia. washers, (Item #1), see Figure 7. Cover with washer (item #3) and gently tap the bearing evenly into
place. When flush use the second washer (Item #1) and keep driving until the face of the bearing is below
the retaining ring channel. Remount the retaining ring.
Figure 7. Pulley side bearing with one of the two washers (Item #1) covering.
Step #6: Packing the seals
Pack the Amblygon grease into the space between the seals and generously coat the five seal lips that
will contact the shaft. Apply a thin film of Amblygon grease to the Seal Face Bushing (SFB) at the base of
the shaft and the shaft-bearing contact areas.
Step #7: Seat the rear drum assembly onto the shaft/mantel assembly
With the inner drum/shaft resting on the floor, carefully align the bearing housing assembly over the shaft
and allow gravity to assist seating the assembly onto the shaft making sure to not to damage the seals as
the shaft is fed through them. The shaft-bearing interface is a slip fit and it should only require a delicate
push to seat into place. When seated, the shaft end will stand 7/16" (1.1 cm) proud of the pulley housing.
You can confirm proper assembly by a test fit of the pulley wheel to see if the shaft end is flush with the
pulley bolt mounting area, see figure 8. To make insertion of the drum-assembly into the chassis easier,
final mounting of the pulley wheel should be done AFTER the reassembled drum is reinstalled in the
machine