Laundrylux CROSSOVER 2.0 Series, Training Manual

Page: 43 / 74

Error code “Er1c”: Door fails to unlock at end of cycle (Display shows “dOnE”)
Models : WHLFP715M/MI/NM/DC
WHLFP817M/MI/NM/DC
Error Trigger
INTELOCK voltage present at U1:CN2 after door unlock pulse sent
Recommend actions:
Use doorlock diagnostic flowchart to determine cause.
Error code Er1d: Door closed switch (S3) opened during wash program
Models : WHLFP715M/MI/NM/DC
WHLFP817M/MI/NM/DC
Error Trigger
Door closed switch (S3) open longer than 60 seconds accumulated time during wash program.
Recommend actions:
1. Use doorlock diagnostic flowchart to determine if fault exists. If OK, then, run cycle with no load. If
OK, then
3. Confirm that machine is not being overloaded or that people are not pulling on doors during
operation.
Warning code “door”: S3 switch open
Models: WHWF09810M/NM
Trigger
STANDBY : S3 switch open when START pressed with no payment due.
DURING CYCLE : S3 switch open during wash cycle due to overloaded drum or pulling on the door.
Recommended actions: Standby:
1. Close door and retry
2. Use the door lock diagnostic flowchart to determine if fault exists.
Recommended actions: RUN Confirm machine is not overloaded and oversuded
1. Reduce water levels, Registers 20 and 21 to = 25 maximum.
2. Use the door lock diagnostic flow chart.