Lauda Viscotemp 15 G, Operation Manual

Page: 24 / 132

24 / 134
ECO Gold 09/2021
6 Before putting the device into operation
Please note:
-
The device can be operated up to an ambient temperature of 40 °C.
-
A higher ambient temperature can have a negative effect on the cooling output of the thermostats used.
-
When putting the chiller into operation after a lengthy shut-down, up to 30 minutes may pass until the rated refriger-
ating power is available depending on room temperature and device type.
6.1 Assembly and siting
Always comply with the following safety information:
Warning!
Falling / toppling equipment on sloping surfaces / table edge
Crushing of hands and feet

Only site the device on flat surfaces, not near the edge of
the bench or table.
Affix the symbol "Hot surface".
The ECO thermostat is used as:
-
Immersion thermostat (optionally with cooling coil and/or pump connection set),
-
Heating thermostat (heating bath and circulation thermostat),
-
Cooling thermostat (cooling/heating bath and circulation thermostat).
Assembly as immersion thermostat
-
Push the screw clamp on the underside of the control head
into the guide rails.
-
Insert the thermostat with the screw clamp into the tem-
perature control vessel (

9) and screw the clamp tightly to
the bath edge with the knurled screw.
-
With plastic baths the tubular heating element must not
contact the bath wall.
-
Ensure that the ventilation opening at the back of the device
is free.
-
Keep a distance of at least 20 cm free on all sides of the de-
vice.