59
Fault/Error Function
Meaning
Cause
Remedy
This error is reset after
15 seconds. During
this time, the door
drive does not respond
to input drive signals.
If input drive signals
are present, the door
drive starts with a ref-
erence movement at
slow speed.
The toothed belt ten-
sion has been
changed.
Start the self-learn
procedure (see also
7.4 Self-Learn Proce-
dure / page 27)
E2
EEPROM errors
If an EEPROM error
occurs, the drive is
brought to a stop.
Hardware may be
faulty.
Replace TSG elec-
tronic.
E3
Obstructed for revers-
ing
The door drive has de-
tected an obstacle and
reversed itself. The
door was obstructed
during reversing.
There is an obstruc-
tion in the door.
Check the travel path.
(see also E1)
The door drive re-
verses due to the trig-
gering of the external
sensor. The door was
also blocked during the
reversion.
The door drive has de-
tected an obstacle and
reversed in the open
direction. During re-
versing, the external
sensor is also trig-
gered.
E4
Encoder signals are
not unique or do not
exist.
No signal from the en-
coder
Cable to the incre-
mental encoder is not
connected.
Connect the cable with
the incremental en-
coder.
Cable to the incre-
mental encoder dam-
aged.
Replace the incremen-
tal encoder cable.
Cable to the motor is
not connected.
Connect the cable with
the motor.
Cable to the motor
damaged.
Replace the motor ca-
ble.
Assignment of the
motor connection
changed.
Check motor connec-
tion (see also Table
28: X4 motor connec-
tion / page 73)
Summary of Contents for TSG V4
Page 1: ...1 Installation and Operating Instructions for the device series Door Operator TSG V4...
Page 82: ...82...
Page 83: ...83...
