37
Function
Note
Min De-
fault
Max Factor
Unit
b8
Response of relay output "Door
Obstructed" in Open direction
oF = Continuous
on = Pulse
oF
on
on
b9
Response of the door drive for
blocking in Open direction
oF = if door is obstructed the drive
will stop immediately. If the input
signal changes to "Close door", the
door closes.
on = automatic reversing for input
signal "Open door" until the Closed
position is reached. If the input sig-
nal "Open door" is still present, the
door will then open again immedi-
ately.
oF
oF
on
bA
Length of the output pulse on
relay output "Door Obstructed"
in Open and Close direction
Only in effect if b3 and/or
b8 = on
0.1
1.0
2.0
[sec-
onds]
bb
Catch range for Door Closed
position
Caution:
Obstructed detection is
not active in this range!
01
05
50
[mm]
bC
Catch range for Door Opened
position
Caution:
Obstructed detection is
not active in this range!
01
10
50
[mm]
bd
Distance of reversing
Effective for obstacle detection and
sensor monitoring.
1. Obstacle detection:
If the door is blocked, the TSG re-
verses by the set value. If the
value is set to 00 or 99, a complete
reversal takes place.
Attention:
Only active if parameter
b4 or b9 has been activated.
Attention: The smallest reversing
range to be carried out is 5[cm].
2. Sensor monitoring:
If the sensor is triggered when
closing, the TSG reverses by the
set value. If the value is set to 99,
a complete reversal takes place.
Attention:
The smallest reversing
range to be carried out is 5[cm].
00
99
99
[cm]
bE
Slow travel when door blocked. If the door is blocked in the close
direction, the TSG will drive slowly
on the next closing run until it
reaches the position of the block-
age.
oF
on
on
CC Exit the menu.
Select CC and press the jog wheel to leave the b-parameter menu and
return to c.o.
Summary of Contents for TSG V4
Page 1: ...1 Installation and Operating Instructions for the device series Door Operator TSG V4...
Page 82: ...82...
Page 83: ...83...
