Langer & Laumann TSG V4, Installation And Operating Instructions Manual

Page: 32 / 84

32
8.2 Basis settings
The TSG default parameters are pre-configured. Normally the default parameter’s settings do not need to be
changed.
WARNING:
The adjusted parameters, the maximum speed limit, force and energy are to be checked and
recorded at the closing and shearing edges after commissioning or changing of parameters at
the door by the executive personnel (see also cap. 11 Setting for force limiting / page 51).
8.3 User setting – P parameters
P parameters are used to set drive values quickly.
If you press the jog wheel, the TSG will switch to the Parameter menu. The first appearing menu item is P0.
Turning the jog wheel clockwise (c.w.) increases the parameter menu, while turning it anticlockwise (c.c.w.)
reduces the menu.
To see the values of the relevant parameter, press the jog wheel briefly.
Table 9: P parameters
Function Note Min Default Max Factor Unit
P0 Return to special functions (see also cap.9.2 Advanced menu / page 35)
P1 Manual mode (see also cap. 7.6 Manual mode / manual travel / page 30)
P2 Max. Open speed 01 50 99 0,01 [m/s]
P3 Max. Close speed 01 30 99 0,01 [m/s]
P4 Locking and unlocking speed Creep speed shortly before
Door Closed end position 01 05 P3 0,01 [m/s]
P5 Acceleration and braking in Open
direction 01 07 50 0,1 [m/s²]
P6 Acceleration and braking in Close
direction 01 07 50 0,1 [m/s²]
P7 Locking and unlocking distance Creep distance shortly be-
fore Door Closed end posi-
tion 00 03 99 1 [cm]
P8 Limit value „Obstructed detection“
in Close direction 0.1 4.0 9.9 1
P9 Activation of self-learn procedure (see also cap. 7.4 Self-Learn Procedure / page 27)
CC Exit the menu. Select CC and press the jog wheel to leave the P-parameter menu.