Langer & Laumann TSG V4, Installation And Operating Instructions Manual

Page: 35 / 84

35
9.2 Advanced menu
To go to the advanced menu mode, select parameter P0 and hold down the jog wheel for about 5 [seconds].
Then you can turn the jog wheel to select parameters c, b, h, E, r and Au (see also Fig. 20: Menu structure /
page 26).
CAUTION:
In certain cases, changing the value of a “P” parameter will automatically change some of the
“C” parameter values (see also Fig. 25: or Fig. 26: / page 34). This means that the value which
is set in the P parameter automatically enters in the corresponding C parameters.
9.2.1 User setting – c parameters
The c parameters can be set individually.
Table 10: c parameters
Function Note Min Default Max Factor Unit
c0 Length of creep distance in Open di-
rection
00 00 (internal calcu-
lation) [cm]
c1 Creep speed in Open direction
01 05 P2: Open speed 0,01 [m/s]
c2 Length of unlocking distance in
Open direction
00 03 (internal calcu-
lation) [cm]
c3 Unlocking speed in Open direction
01 05 P2: Open speed 0,01 [m/s]
c4 Length of unlocking distance in
Close direction
00 03 (internal calcu-
lation) [cm]
c5 Locking speed in Close direction
01 05 P3: Close
speed 0,01 [m/s]
c6 Acceleration in Open direction
01 07 50 0,1 [m/s²]
c7 Braking in Open direction
01 07 50 0,1 [m/s²]
c8 Acceleration in Close direction
01 07 50 0,1 [m/s²]
c9 Braking in Close direction
01 07 50 0,1 [m/s²]
cC Holding torque in Open direction
without input signal "Open door"
0.0 1.0 2.5 [A]
cd Holding torque in Close direction
without input signal "Close door"
0.0 1.0 2.5 [A]
cE Holding torque in Open direction
with input signal "Open door"
0.0 1.0 2.5 [A]