58
12.5 Mechanical transmission adjustment
A permanently set gear ratio is stored in the TSG door control unit as standard. A changed mechanical trans-
mission has the consequence that the forces, the speeds and the accelerations are different from the ex-
pected ones. To compensate for the difference, the existing mechanical transmission ratio in the TSG door
control unit can be adapted.
NOTE:
See also the manual:
1.20.91515 TSG Application Note Mechanical Ratio
13 Troubleshooting
In case of a fault, the TSG door operator will indicate a fault on the display (see also Table 13: E parameter /
page 43).
Table 17: E parameters - error elimination
Fault/Error Function
Meaning
Cause
Remedy
E0
Door travel not limited The travel of the door
is not limited or no end
position found.
End position in open
direction is not de-
fined.
Check the mechanic of
the door.
End position in close
direction is not de-
fined.
Check the mechanic of
the door.
Toothed belt failed.
Check the mechanic of
the door.
E1
Door travel path
locked
The door does not
move.
This error occurs out-
side the range of "Ob-
structed detection“!
Within the range of
"Obstructed detection",
the "Obstructed out-
put" is set and "bl" ap-
pears in the display.
The current door travel
distance is less than
the programmed door
width.
(see parameter set
"b.l".)
The door lock has not
been unlocked.
Check the door me-
chanics.
There is an obstruc-
tion in the door.
Check the door travel
path. Remove the ob-
struction.
The initial measure-
ment movement of
the door is incorrect
or has not been per-
formed.
Start the self-learn
procedure (see also
7.4 Self-Learn Proce-
dure / page 27)
The buffer-type stops
for the "Closed posi-
tion“ or "Opened posi-
tion" are missing or
have been incorrectly
adjusted.
Start the self-learn
procedure (see also
7.4 Self-Learn Proce-
dure / page 27)
Summary of Contents for TSG V4
Page 1: ...1 Installation and Operating Instructions for the device series Door Operator TSG V4...
Page 82: ...82...
Page 83: ...83...
