3-7
TOOTH BAR ASSEMBLY - 18’ MODELS
3-7.1
Lift front and rear tooth bar assemblies into
position and secure retainers to the four
frame hangers using 1/2” x 1-1/2 bolts, lock-
washers, and nuts
(See Figure 3-8)
. Be sure
to mount the retainers on the inside of the
frame hangers.
a.
For 17” rollers, the retainers are attached in
the upper holes of the hanger brackets.
b.
For 19” rollers, the retainers are attached in
the middle holes of the hanger brackets.
c.
For 20” rollers, the retainers are attached in
the lower holes of the hanger brackets.
3-7.2
Attach the front link assembly to front link
bracket and transport axle lever with 1” SAE
flat washers and 1/4” x 2-1/4” cotter pins.
Mount the rear link assembly to rear link
bracket and transport axle lever with linkage
pins, 3/8” x 2-1/2” spring pins, and 1/4” x
2-1/4” cotter pins.
3-11
Figure 3-8 Tooth Bar Assembly - 18’ Models
Summary of Contents for 3210 Series
