3
ASSEMBLY INSTRUCTIONS
3-1
ASSEMBLY - SAFETY
It is very important that your new 3210 Series
Mulcher be properly assembled, adjusted and lubri-
cated before use. Illustrations in this section show
proper assembly procedures. Remove paint from
grease fittings. Replace any grease fittings that are
damaged or missing. Be sure to return screws,
clips, etc., to their original locations.
To insure alignment of assemblies,
leave the
nuts loose until completion
of final assembly.
Use lock washers or flat washers as specified.
Spread all cotter pins.
After completion
of final assembly,
tighten all
nuts evenly
to prevent misalignment, distortion or
binding. Tighten all screws and nuts to the recom-
mended torques shown in
Tables 2-1 and 2-2
.
CAUTION
1. THE PERSON OR PERSONS WHO
ASSEMBLE THIS MACHINE MUST
HAVE THE ABILITY TO READ, UNDER-
STAND AND FOLLOW THE STEP BY
STEP ASSEMBLY PROCEDURES AND
SAFETY INSTRUCTION OUTLINED
HEREIN.
2. ASSEMBLY AREA SHOULD BE
LEVEL, CLEAN AND FREE OF DEBRIS
TO PREVENT ASSEMBLY PERSON-
NEL FROM TRIPPING OR FALLING.
3. INSPECT ALL PARTS FOR SHARP
EDGES, GREASE, OIL OR DIRT WHICH
MIGHT CAUSE INJURY DURING AS-
SEMBLY.
3-1
Summary of Contents for 3210 Series
