ASSEMBLY INSTRUCTIONS FOR L&L FUEGO AND ROBIN KILNS
fuego-robin-assembly.pdf
REV: 4/1/2017
Page 3
2017
L&L Kiln Mfg, Inc. 505 Sharptown Rd, Swedesboro NJ 08085 P:856.294.0077 F:856.294.0070 [email protected] hotkilns.com
The kiln base positioned on the stand.
ASSEmBLING WITH TWO PEOPLE
If you have two reasonably strong people available you
can lift the whole kiln with the two sections and the top
attached without disassembling the panel. (If you have only
one person - skip this section and use the single person
assembly technique).
CAUTION: The two kiln sections and top together of
the Robin weigh about 70Kg (150 pounds). Be careful
not to strain yourself. The Fuego weighs less and a
strong person can probably lift this by themselves.
1) Pick up the kiln using the handles on the bottom section
and place it on the bottom slab. Adjust it until the bottom
section matches the bottom slab.
Manuvering the kiln using the handles on the bottom
section.
2) Your kiln is now fully assembled and ready to operate.
ASSEmBLING WITH ONE PERSON
REmOvING THE CONTROL PANEL
1) Remove one of the Cotter Pins from the hinge bar.
Removing a cotter pin.
2) Remove the Hinge Bar from the flanges on the control
panel and the hinge bracket on the kiln lid.
Removing the hinge bar.
3) Set the kiln lid to the side of the top section. There is
no need to remove the support chains unless you want to
completely remove the kiln lid.
