LAGUNA
TOOLS
53
Memory Error
Insufficient or bad memory.
Multiple Commands
Input line contains more than one command.
Not a BMP File
Tried to open a non-bmp file for bitmap engraving.
Parameter Not Specified
A required parameter is not specified.
Parameter Out of Range
Specified parameter is out of range.
Pausing.....
Motion is pausing.
Pump Control Not Enabled
The pump control feature has not been enabled.
Runtime: #d Minute(s) and #f Second(s)
Run time for the last file in minutes and seconds.
Soft Limit Exceeded
Move specified would result in the head being moved outside the soft limits.
Soft Limits Not Enabled
Softlimits are set as disabled.
Subprogram Nesting Too Deep
Too many nested subprogram calls.
Tangential Knife Not Enabled
The tangential knife feature is not enabled.
Tool Changer Not Enabled
Tool changer is not set up in the WINCNC.INI file.
Unknown
An unknown error has occurred.
Unknown
An error has occurred that is undefined in WinCNC.
Unknown Position Specified
The position specified is invalid.
Unsupported G Code
G Code in input line which is not supported.
Unsupported L Code
L Code in input line that is not supported or ignored.
Unsupported M Code
M Code in input line which is not supported.
Upgrade needed for Key Version 5, or 6
Axis card
And upgrade of the daugtherboard is needed.
User Level 5 Required
A Level 5 user license is required.
Vector Laser Not Enabled
Vector laser feature not enabled in the software.
Wrong Key Found
The software key found is incorrect.
Summary of Contents for CNC Swift Series
Page 54: ...LAGUNA TOOLS 54 SPECIFICATIONS...