LAGUNA
TOOLS
51
M37.3 is used to shift workspace offsets for tool measures, tool measure switch heights, or individual axis.
S# is the shift amount to be used for tool measures and tool measure switch positions. (usually a negative #).
H# is the H register number to be shifted by the shift amount. H0 will shift all H registers.
T# is the tool number height to be shifted by the shift amount. T0 will shift all tool numbers.
M# is the measure switch height to be shifted by the shift amount. M0 will shift both switches.
X# Y# Z# ... shifts each axis workspace offsets by the specified value.
M98
Subprogram Call - M98 <filename>
Run a subprogram. A subprogram may be any G-Code file. Control is passed back to the calling program
when finished. To run a G90 mode subprogram from any position on the table use G92X#Y#Z#W# to set the
local coordinates at the beginning of the file.
M98.1
Subprogram Call - M98.1 <filename>
Same as M98, except line numbers in the subprogram are not counted. This is most useful for macros that
call subprograms.
M99
End Subprogram
Ends a subprogram.
M99.1
Abort
Initiates a commanded program abort.
MESSAGES
AND
ERROR
CODES
Error
codes
will
be
displayed
in
the
message
display
window
of
the
screen
display.
The
list
below
is
in
alphabetical
order.
2-Bit Bitmap Engrave Not Enabled
Tried to open a 2-Bit bitmap without the feature being enabled in the
software.
8-Bit Bitmap Engrave Not Enabled
Tried to open an 8-bit bitmap without the feature being enabled in the
software.
Aborted By User
Escape button pushed while running.
Acceleration Out of Bounds
Acceleration rate too high for resolution. Maximum (acc*res) in steps is
65535.
Arc Radius
Distance from start point to center is not equal to distance from endpoint to
center. Arc Radius errors can occur from running a G2 or G3 intended for
G91 mode in G90 mode and vice versa.
Arc Too Small
Specified arc move is too small.
Arcs Disabled When X or Y scaled
Rotating Saw Not Enabled
When scaling is enabled, arcs are not supported.
The rotating saw feature is not enabled.
Auto-AuxOut Not Enabled
User has tried to use an Auto-AuxOut without the “autoaux=” line being set
in the WINCNC.INI file.
Summary of Contents for CNC Swift Series
Page 54: ...LAGUNA TOOLS 54 SPECIFICATIONS...
