Kyocera DF-420, Service Manual

Page: 63 / 296

3MX
1-5-8
(2) Adjusting the angle of trailing edge
Perform the following adjustment if the trailing edge of the copy image is laterally skewed.
Procedure
1. Place an original on the DP and press the
start key to make a test copy.
2. If the gap of trailing edge exceeds the refer-
ence value, perform the following adjust-
ment.
Reference value
For simplex copying: Within ±3.0 mm
For duplex copying: Within ±4.0 mm
Figure 1-5-8
3. Open the DP and release two latches using
a flat-head screwdriver.
Figure 1-5-9
4. Release three latches using a flat-head
screwdriver and remove the document pro-
cessor rear cover.
Figure 1-5-10
3 mm/4 mm 3 mm/4 mm
Original Copy
example 1
Copy
example 2
Latches
Latch
Latch
Document processor
rear cover
Latch