Kyocera DF-420, Service Manual

Page: 173 / 296

3MJ
1-5-2
Trailing edge
registration cursor
Front side
registration cursor
Rear side
registration cursor
Enter maintenance mode.
Make a test copy
in staple-sort mode.
Press the start key.
Press the start key.
Press the stop key to
exit maintenance mode.
Enter 246 using the numeric
keys.
Yes
Yes
No
No
Start
End
Change the setting using the
cursor left/right keys.
Is the paper registration
good?
Is the stapling
position correct?
See Figure 1-5-1.
The new setting
is stored.
Select the item to be adjusted.
FRONT: Stop position of the front side
registration cursor
REAR : Stop position of the rear side
registration cursor
END : Stop position of the trailing edge
registration cursor
Setting range: 0 to 8
Initial setting: 4
Changing the value by 1 changes the
position by 0.566 mm.
Decreasing the value moves the front or
rear side registration cursor or trailing
edge registration cursor outward ( );
increasing the value moves each cursor
inward ( ). See Figure 1-5-2.
(2) Adjusting the positions of the front side registration cursor, rear side registration cursor and trailing edge
registration cursor (reference)
Perform the following adjustment if paper registration is poor or stapling is made outside the specified area.
Procedure
Figure 1-5-1 Stapling position
Figure 1-5-2
Staple
5 ± 4.0 mm
5 ± 4.0 mm