Kyocera Mita Ecosys FS-1800, User Manual

Page: 211 / 249

Expansion Memory Installation
B-6
Removing DIMM
To remove a DIMM, carefully pull the end clips outwards, then pull the
DIMM out of the socket.
Reverse the procedure under
Withdrawing the Main Circuit Board from
the Printer to put the main circuit board back into the printer.
Testing the Expansion Memory
After you have finished installing DIMM in the printer, test the printer to
see if the installation has been successful.
To test the expansion memory, proceed as follows:
1
Make sure the power switch is off. Plug the power cord into the
printer and turn power on.
2
Press the
MENU
key on the operator panel.
3
Press the or key repeatedly until the message display shows
Print Status Page
.
4
Press the
ENTER
key twice.
5
If the installation has been successful, the amount of memory shown
on the status page will correspond with the amount of expanded
memory. (The factory installed memory size is 8 MB for the FS-1800
and 16 MB for the FS-3800.)