Kyocera Mita Ecosys FS-1800, User Manual

Page: 50 / 249

Operating the Operator Panel
1-40
Setting the Interface for Operator Panel
The printer is equipped with both a parallel and serial interface.
Independent settings can be made for each interface. Optional interface
can also be installed.
This interface selection does not select which interface data will be
received from. The printer automatically selects that interface.
Parallel Interface
The parallel interface mode of this printer supports a bi-directional/high-
speed mode. Normally, this inter-face is used under the default setting
AUTO
. For details about modes, see Appendix C . After setting the
interface, be sure to reset the printer or turn the power off at least once.
The new setting will be enabled thereafter.
1
Press the MENU key.
2
Press the
or
key and select.
Interface >
. The current
interface is indicated by one of following messages:
Parallel
(default)
Serial
Option
(if installed)
3
Press the ENTER key. The message display shows a blinking
question mark (
?
).
If
Parallel
is not displayed, press the
or
key and select
Parallel
.
If you want to abandon the interface selection procedure, press the
CANCEL key. The interface remains unchanged.
4
Press the ENTER key again.
5
Press the > key. The message display changes to the communication
mode menu.
Interface >
Parallel
Note
MENU
ENTER
Interface >
? Parallel
ENTER
?