Kyocera Mita Ecosys FS-1800, User Manual

Page: 175 / 249

Indicators and Messages
4-7
4.3.2 Maintenance Messages
The following table lists maintenance messages that can be dealt with by
the user.
Message Corrective Action
Add paper
(paper source) The paper has run out. Supply paper according to the paper source displayed (paper
cassette, MP tray, or optional paper feeder).
Messages indicating the printer status (
Ready
,
Please wait
,
Processing
*,
Waiting
, and
Form Feed Time Out
*) are displayed alternately.
* These messages will not appear if the number of copies is set to 2 or more.
Call service
personEn:0123456
Mechanical error (n=
0
,
1
,
2
, ...)-Call a service person. The printer does not operate
when a message beginning with
E
is displayed. The total number of pages printed is
also indicated.
Call service
personFn
Controller error (n=
0
,
1
,
2
, ...)-Call a service person. The printer does not operate
when a message beginning with
F
is displayed.
Check waste
toner bottle
Replace the old waste toner bottle with the new one which is included in the TK-60/
TK-60E toner kit. The message will also be shown if the waste toner bottle has
become full. The waste toner bottle should be replaced when the message display
eventually shows
Toner low TK-60
. See section 3.1 Toner Container
Replacement on page 3-2 .
Clean printer
Press GO
Please clean the inside of the printer. See section
3.3 Cleaning
on page
3-9
.
This message will be displayed when replacing the toner container after the message
Replace toner TK-60
has been displayed. After cleaning the inside of the printer,
press the
GO
key and the printer will be ready for printing.
If Auto Continue is set to
On
, printing will be automatically resumed after a preset
period of time.
Duplexer
rear cover open
Open the option duplexer rear cover, then close tightly.
Face-down tray
paper full
The face-down tray has become full (approx. 250 pages). You must remove all printed
pages from the face-down tray. When the printer senses that the face-down tray is
empty again, it will continues printing into the face-down tray.
Load Cassette #
(paper size)
/
(paper type)
*(paper size) and (paper
type) are displayed flashing
alternately.
There is data for printing that matches with a paper cassette setting (paper size,
paper type), but there is no paper in the cassette.
Set paper into the paper source as displayed on the control panel, and press the
GO
key to restart printing. However, the paper source number (
#
) is only displayed
when there is an optional paper feeder installed.
Or, if you want to print from a different paper source press the
GO
key to display
Use
alternative?
and you can change the source for paper feeding. Further, you can
change the paper source by pressing the
GO
key.
After selecting a paper source and pressing the
MODE
key,
Paper handling >
appears. By pressing the
>
key, the paper type settings menu appears. After setting
the correct paper type, press the
ENTER
key and printing starts.
:Alarm buzzer sounds when an error occurs.
(Continued on next page)
!"
!"
!"
!"