KW DAVID 613, Operating Manual, Page: 99 / 264

KW Aufzugstechnik GmbH OPERATING MANUAL DAVID-613
DAVID-D613-V125-E 13.04.2021 Page - 99 -
B32 – Hydraulic Variable Frequency
PARAMETER : V0 DELAYED OFF
The parameter contains the attitude to switch the speed V0 off retarded. The standard value is NO.
PARAMETER : MAIN CONDUCTOR DELAYED OFF
The parameter contains the attitude to switch off the main contactors retarded. The standard value is
600 ms.
PARAMETER: DIRECTION DELAYED OFF
Time-delayed will the removal of the driving direction, in order to ensure stopping without jerking. The
deceleration time is adjustable in the menu. As default value are deposited 1500 ms.
PARAMETER : RELEVELING SPEED
Some regulation cannot display speed Vn for post-correction. It can be selected by the menu attitude
whether the releveling time is accomplished with the speed Vn or V0.
PARAMETER: INSPECTION SPEED
Some regulation has no inspection speed Vi. It can be selected by the menu attitude whether the in-
spection speed is accomplished with the speed Vi or V0.
PARAMETER: TIME TO GO DOWN
The hydraulic elevator must lower after 15 minutes to the lowest stop place. The time is adjustable by
this parameter.
PARAMETER: FAULT HANDLING
By the menu attitude can be selected, as the control has to react to error messages of the regulation.
a) “NO”- regulation does not have a disturbance exit.
b) “STOP + LOWERING”- If there is an error in the regulation, the driving instructions are
taken back and the calls are deleted. The car is lowered into the lowest stop place.
PARAMETER: TIME TO GO DOWN AT OVERLOAD
Is overload in the car, it must be decided at expiration of the sinking time whether lower or not. The
standard value is NO.
PARAMETER: BLOCKING UPPER LIMIT-SWITCH
If the car was in the upper limit switch in normal operation, then the car is lowered and closed into the
lowest floor. During the attitude of kind of condition this paramenter is active.
PARAMETER: COMMAND OUTPUT
With this parameter can be adjusted, as the expenditure for command takes place to the regulation.
Two variants are available:
1) With hydraulic BUCHER SATURN -Alpha
2) With hydraulic ALGI AZFR (code output)
PARAMETER: COMMAND DOWN DELAY ON
The parameter has the opportunity to switch on delayed Down Direction. This is needed for usage of
reflow preventing valve (ALGI-S5). Default value is NO.
PARAMETER: ELEVATOR BUS
After market introduction of the device SAG-90 it is possible that the controller communicates by bus
with control.
PARAMETER: WARM UP DRIVE
With this parameter you can operate the termperature input (Assigned with function E492 temperature
Warm Up Drive ). A drive starts to warm up the oil.
PARAMETER: WARM UP DRIVE AFTER XX MINUTS
In this parameter you can choose the start time of the Warm Up Drive. Start time is always after lower
drive. The maximum time is 1250 minutes.