KW DAVID 613, Operating Manual, Page: 220 / 264

KW Aufzugstechnik GmbH OPERATING MANUAL DAVID-613
DAVID-D613-V125-E 13.04.2021 Page - 220 -
end switch- TOP
end switch-TOP
position: xxx,000m
Normal operation
menu
Display of the switch position top in m.
Position: xx, xxxm
The absolute position of the upper, taught-in limit
switch is displayed here.
end switch-BOTTOM
end switch-BOTTOM
position: xxx,000m
Normal operation
menu
Display of the switch position down in m.
Position: xx, xxxm
The absolute position of the lower taught-in limit
switch is displayed here.
dec. monitor BOTTOM
Dec. monitor-BOTTOM
Control above: Off/On
Normal operation
menu
Indication of whether the deceleration control
was activated below.
Off / Position: xx, xxxm
Here, you can see if the delay check below when
configuring the
SAFE copy disabled or enabled. If this has been ac-
tivated stands
there the absolute position of the monitoring point.
decel. Monitor TOP
decel-monitor-TOP
Control above: Off/On
Normal operation
menu
Indicates whether the delay control has been
activated above.
Off / Position: xx, xxxm
Here, you can see if the delay control above in the
configuration of the
SAFE copy disabled or enabled. If this has been
activated stands
there the absolute position of the monitoring point.
floors - ANTSSAFE
floors ANTSSAFE: 04
floors D613: 04
Normal operation
menu
Here, the number of floors of the SAFE copy
and the floor number of the control D613 is dis-
played in comparison.
Here, the number of taught-in levels of the SAFE
copy after the
Learning trip and the specified number of floors in
the shaft shown.
Both floor values must have the same value after
commissioning!
D9 ANTSSAFE - Software
ANTSSAFE-Software:
CRC: xxxxxxxx
Normal operation
menu
Here, the CRC sum of the safe core of the
Sil-3 software is displayed.
Here, the CRC sum of the safe core of the Sil-3 soft-
ware is displayed. This sum should match the value
of the certificate of the type examination certificate.
Off and On switches rewatch the CRC value. The
CRC sum may vary depending on the software ver-
sion.