Kverneland 2316M, Technical & Service Manual

Page: 33 / 60

Disassembly gearbox
Disassembly gearbox
Disassembly gearbox
Disassembly gearbox
Disassembly gearbox
Disassembly gearbox
• Disassemble shim (10) and
snap ring (28).
• Disassemble inner ring (3),
using chisel and hammer or
extractor.
• Hit the crown wheel (5) from
side (B) in order to extract it
from shaft (11), using pipe or
chisel and hammer.
• Pick up inner ring (8).
• Take away parallel key (6),
using pliers.
Tools : Chisel, hammer, snap
ring pliers, extractor.
• Disassemble oil seal (22),
using chisel and hammer.
• Disassemble snap rings (17)
and shim (23).
• Hit the pinion shaft (25) in
order to extract it from
housing, pick up outer ring
(24).
• Disassemble inner ring (24)
from pinion shaft (25), using
chisel and hammer or
extractor.
• Unscrew bolt (21) and
disassemble washer (20),
shims (14),(26), gear (19).
• Disassemble bearing (18)
from gear (19), using chisel
hammer.
Assembly gearbox
Assembly gearbox
NOTES
• Clean all the components
from remaining grease and
silicone.
• Replace any particular
damaged. When assembling
the ball bearings and taper
roller bearings, pay attention
to not make any pressure on
the cages in order to avoid
any damage.
• When assembling oil seals
avoid contact with cutting
parts in order to prevent any
damage to the inner lip.
• Insert oil seals taking care or
greasing the zone of contact
between oil seal and shaft.
5.3.2 Gearbox repair instructions
33