7-8
Setup Mode
The Channel/Program (CH/PROG) Page
Entry Program Change (EntryProgChg)
This parameter enables or disables bank and program change commands sent to internal
programs or to the MIDI Out jack when you select setups. If it’s set to
On
, the program numbers
for the programs in the 16 zones will be sent via MIDI when a setup is selected. By setting this
parameter to
Off
, you can select a setup on the PC3A without changing the internal programs or
those on MIDI devices receiving from the PC3A. This is useful if you want to send only controller
data to the PC3A or to MIDI devices, without changing program assignments.
Arpeggiator
The
Arpeggiator
parameter determines if the current Zone can be played by an arpeggiator.
Normally, the
Arpeggiator
parameter should be set to On, and the arpeggiator for each Zone
should be turned on or off with the Active parameter on the ARPEGGIATOR page for each Zone
(see
The ARPEGGIATOR Page
on page 7-42
for details.) If the
Arpeggiator
parameter is set to Off,
the zone will not be arpeggiated even if the Active parameter on the ARPEGGIATOR page is set
to On.
When a global arpeggiator is being used, the
Arpeggiator
parameter can be set to
Off
to exclude
a Zone from being played by the global arpeggiator. See
Arpeggiator Global (ArpGlobal)
on page
7-66
for details on setting a global arpeggiator.