Kurz 410FTB, Operation Manual

Page: 94 / 165

Kurz B ‐ Series Operations Guide 4–21
Program Mode Advanced Setup
Option 9 — Setting Up Alarms
The flow meter can be manufactured to support up to two alarms. The alarms can be monitored
on the display, via ASCII or Modbus commands, or through the HART interface. Additionally, the
alarms can be setup to send a control signal (energize a relay output) when an alarm event
occurs.
Note
It is recommended that you start with the Option 8, Relay Output Setup ,
to avoid assigning conflicting relays. See “Option 8 — Setting Up Relays”
on page 4 ‐ 19 for information.
Note
As the relays are optically isolated solid ‐ state relays (SPST switching),
their non ‐ powered state is an open circuit and must be considered for
fail ‐ safe alarm logic configurations.
Note
The alarm relays are rated for 0.5A.
To access the Alarm Setup menu in Program mode:
1>
Press P .
2>
Enter the Advanced access code, and then press E .
3>
Press 2 to invoke the Quick Jump option.
4>
Press 9 for the Alarm Setup menu, and then press E .
The following information appears if the meter was not purchased with the alarm
option:
ALARM FUNCTION
IS NOT INSTALLED
If you would like the Alarm function available, contact the Kurz representative.
If the meter is configured with the alarm option, you are prompted for an alarm
number.
SET ALARM #
>1
5>
Use the numeric keys to enter either 1 or 2 for the alarm number, and then press E .
SET ALARM 1
>ON
You are prompted to turn the alarm ON or OFF.