Kurz 410FTB, Operation Manual

Page: 85 / 165

Kurz B ‐ Series Operations Guide 4–12
Program Mode Advanced Setup
Option 5 — Setting Up Analog Output 1
The output and signal range for process variables measured by the flow meter are configured
through the Analog Output Setup menu in Program mode. The receiving device must be
programmed for the same range.
The flow meter supports up to two analog output (AO) channels. Each analog output channel
(AO1 and AO2) can report flow rate, temperature, velocity, or be assigned to a PID flow controller.
Both channels are active during the zero ‐ mid ‐ span drift check.
The drift check and NE ‐ 43 alarms are temporary overrides to the analog output signals.
To access the Analog Output Setup menu in Program mode:
1>
Press P .
2>
Enter the Advanced access code, and then press E .
3>
Press 2 to invoke the Quick Jump option.
4>
Press 5 for the Analog Out 1 menu and then press E .
The following example uses the Analog Out 1 option with the flow rate feature.
ANALOG OUT 1 >
FLOW RATE ^v
5>
Use the arrow keys to scroll through the list, then press E .
AO1 at 4mA
>0.00000000 SCFM
Table 4 ‐ 1. 4 ‐ 20 mA Output Functions
Analog Output Functions Description
Flow rate
Process measurement. Temperature
Velocity
PID flow controller Control valve position, damper position, or
motor controller speed.
Table 4 ‐ 2. Temporary 4 ‐ 20 mA Process Measurement Override
Drift Check NE ‐ 43 Alarms
Trigger Internal timer
Flow meter error conditions.
Trigger DI2 input