Kubota M100GX, Operator'S Manual

Page: 94 / 178

THREE-POINT HITCH & DRAWBAR 72
B
Top Link
1. Adjust the angle of the implement to the desired
position by shortening or lengthening the top link.
2. The proper length of the top link varies according to
the type of implement being used.
B
Telescopic Stabilizers
Adjust the telescopic stabilizers to control horizontal sway
of the implement. Select the proper set of holes by
referring to the "Hydraulic Control Unit Use Reference
Chart" in "REMOTE HYDRAULIC CONTROL SYSTEM"
in "HYDRAULIC UNIT" section.
After aligning satisfactorily, insert the set-pin through any
one of the five holes on the outer tube that align with one
of the holes on the inner bar, both stabilizers will be
locked.
If the set-pin is inserted through the slot to engage one of
the holes on the inner bar, a limited degree of sway will be
permitted.
B
Quick Hitch (Hook type)
To avoid personal injury:
Confirm the under mentioned matter when
installing the implement:
A
Make sure the hook of a quick hitch is surely
locked.
The 3-point hitch with quick-hitch consists of a pair of
lower links and a top link, all of which have claw ends that
permit rapid attaching and detaching of implements.
C
Installing Ball-joint to Implement
Before the implement is installed on the 3-point hitch with
quick hitches, it is necessary to install the ball-joints to the
implement according to the following instructions.
(1) Adjusting handle (A) "LOCK POSITION"
(B) "UNLOCK POSITION"
(1) Outer tube
(2) Inner bar
(3) Set-pin (4) Hole
(5) Slot
(1) Plain ball-joint (for upper hitch pin)
(2) Ball-joint (for lower hitch pin)