Kubota M100GX, Operator'S Manual

Page: 148 / 178

PERIODIC SERVICE 126
B
Cleaning Pre-Fuel Filter
[M126GX, M135GX]
This job should not be done in the field, but in a clean
place.
1. Close the fuel cock.
2. Unscrew the retainer ring and remove the cup, and
rinse the inside with kerosene.
3. Take out the element and dip it in the kerosene to
rinse.
4. After cleaning, reassemble the pre-fuel filter, keeping
out dust and dirt.
5. Bleed the fuel system.
(See "Bleeding Fuel System" in "SERVICE AS
REQUIRED" in "PERIODIC SERVICE" section.)
B
Replacing Fuel Filter
[M100GX, M110GX]
1. Remove the fuel filter.
2. Put a film of clean fuel on rubber seal of new filter.
3. Tighten the filter quickly until it contacts the mounting
surface.
Tighten filter by hand an additional 1/2 turn only.
4. Bleed the fuel system.
(See "Bleeding Fuel System" in "SERVICE AS
REQUIRED" in "PERIODIC SERVICE" section.)
B
Cleaning Water Separator
[M100GX, M110GX]
This job should not be done in the field, but in a clean
place.
1. Close the fuel cock.
2. Unscrew the cup and remove it, then rinse the inside
with kerosene.
3. Take out the element and dip it in the kerosene to
rinse.
4. After cleaning, reassemble the water separator,
keeping out dust and dirt.
5. Bleed the fuel system.
(See "SERVICE AS REQUIRED" in "PERIODIC
SERVICE" section.)
[M126GX, M135GX]
This job should not be done in the field, but in a clean
place.
1. Unscrew the cup and remove it, then rinse the inside
with kerosene.
2. Take out the element and replace it with a new one.
3. After cleaning, reassemble the water separator,
keeping out dust and dirt.
4. Bleed the fuel system.
(See "SERVICE AS REQUIRED" in "PERIODIC
SERVICE" section.)
A
If a fuel element is broken, replace it with new one.
(1) Fuel cock
(2) Retainer ring
(3) Cup (A) "CLOSE"
(1) O ring
(2) Element
(3) Spring
(4) Cup
(5) Retainer ring
(1) Fuel filter