Kubota M100GX, Operator'S Manual

Page: 145 / 178

123 PERIODIC SERVICE
5. Put a film of clean transmission oil on the rubber seal
of the new filter.
6. Tighten the filter quickly until it contacts the mounting
surface.
Tighten filter by hand an additional 1/2 turn only.
7. After the new filter has been replaced, fill the
transmission oil up to the upper notch on the dipstick.
8. After running the engine for a few minutes, stop the
engine and check the oil level again, add oil to the
prescribed level.
9. Make sure that the transmission fluid doesn't leak pass
the seal on the filter.
A
To prevent serious damage to the hydraulic system,
use only a KUBOTA genuine filter.
EVERY 400 HOURS
B
Changing Engine Oil
To avoid personal injury:
A Be sure to stop the engine before changing the
oil.
A
Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. To drain the used oil, remove the drain plug at the
bottom of the engine and drain the oil completely into
the oil pan.
All the used oil can be drained out easily when the
engine is still warm.
2. After draining reinstall the drain plug.
3. Fill with the new oil up to the upper notch on the
dipstick.
(See "LUBRICANTS" in "MAINTENANCE" section.)
A Use DPF-compatible oil (CJ-4) for the engine.
(1) Hydraulic oil filter
(2) Magnetic filter (Wipe off metal filings)
(1) Dipstick (A) Oil level is acceptable within this range
Tractor model Oil capacity with filter
M100GX, M110GX 10.5 L
M126GX, M135GX 14.6 L