Kubota G18, Operator'S Manual, Page: 136 / 206

118
ENGLISH
IMPORTANT:
¡
To prevent serious damage to the engine,
replacement element of the recommended type
must be used. Use only a genuine KUBOTA filter
or its equivalent.
TRANSMISSION FLUID
쏋
Checking and Replenishment
3
CAUTION
To avoid personal injury:
¡ ¡
¡ ¡ ¡
Be sure to stop the engine and remove
the key before changing or checking the
oil.
¡ ¡ ¡ ¡ ¡
Allow transmission case to cool down
sufficiently; oil can be hot and may
cause burns.
Draw out the dipstick, wipe it clean, replace it, and
draw it out again. Check to see that the fluid level is on
the upper notch.
If low, replenish through the fluid port.
Use UDT or SUPER UDT hydrostatic transmission
fluid or its equivalent (See page 98).
(1) Transmission fluid port (A) “UPPER LEVEL”
(2) Dipstick (B) “LOWER LEVEL”
The fluid in the transmission case is also used for the
hydrostatic drive system.
1.
To drain the transmission case, place oil pan
underneath the transmission case and remove
the drain plug at the bottom of the transmission
case.
2. After draining, disassemble and clean the
strainers and change the oil filter cartridge. After
reassembling, fill with UDT or SUPER UDT
hydrostatic transmission fluid, or its equivalent.
3. After running the engine for a few minutes, stop it
and check the oil level again; add oil to the
prescribed level.